Water Filling Instructions
Fill with cool fresh water only and PLEASE follow these instructions:
- Always grip BUBBLER gently but firmly, watch out slippery when wet and glass can break!
- Carefully wiggle and twist mouthpiece off BUBBLER top
- To Fill: Turn BUBBLER upside down under lightly running cool water, it will fill quickly from the bottom
- BUBBLER is self-regulating, over sink, turn right side up to drain excess water out bottom
- Water will flow through the BUBBLER filtration design
- Inhale/draw on BUBBLER top to level water inside
- Water level will self-regulate approximately better the letters "I" and "Z" in Shatterizer, about half way
- No water should escape the top or bottom of BUBBLER ever
- Dry BUBBLER thoroughly inner coil chamber and exterior
- To Use: Load Shatterizer coil, gently twist and push BUBBLER into place
ENJOY #PerfectClouds and these "Before & After BUBBLER Enjoyment, Tips & Tricks"
- Always use in an upright vertical position, to see the bubbles flow
- Keep Off when not in use, while in travel, and stored in case
- Empty BUBBLER of water when not in use
- ONLY Charge battery, do not charge assembled
- Never store or travel with water filled BUBBLER, it will leak ...
- Rinse thoroughly and carefully before and after use
- Keep dry BUBBLER safe by storing and travelling in case
- Remove storage container and set up in base for desktop mode
- Do not drop, lean on side, lay down, shake, freeze or heat
- Please do not use if cracked, damaged, chipped or broken in anyway